Whirlpool Duet Dryer Not Starting Sensing

Whirlpool Duet Dryer Not Starting Sensing
December 21, 2021 0 Comments

Whirlpool Duet Dryer Not Starting Sensing. As your load of laundry tumbles in the drum, it makes contact with the sensor strips so that the dryer can end the cycle when your laundry is dry. It may not necessarily be a major fault but a small hitch that requires a simple reset or troubleshooting.

Whirlpool Duet Dryer Not Starting Sensing
Whirlpool Duet Dryer Wont Start Stuck On Sensing saintjohn from standartcnr.com

When you activate the washer and dryer, it. It is not likely the belt broke but the thermal fuse is certainly a possibility and i am including in the images below how to access and check the thermal fuse on most whirlpool duet dryers. All whirlpool duet dryers have sensor strips in the drum.

All Whirlpool Duet Dryers Have Sensor Strips In The Drum.

As your load of laundry tumbles in the drum, it makes contact with the sensor strips so that the dryer can end the cycle when your laundry is dry. I verified that the sensors are working by going thru the diagnostics. Whirlpool duet sport dryer model wed8410sw2:

After Reading Thru Other Posts, I Replaced The Control Board But This Has Not Resolved The Issue.

Remove the lower access panel and. It may be because of power issues, a faulty motor, problems with the start button, a blown thermal fuse, or a defective door switch. An open thermal fuse or broken belt will cause the dryer not to start.

The Blinking Light Could Be A Side Effect Of A Dysfunctional Door Switch.

The image below should help with this problem. If the dryer is not level, the sensing does not work properly, and your drying cycle will end early. Sometimes, your whirlpool duet dryer may malfunction.

You Can Troubleshoot Most Of These Problems, But.

This is an easy fix. It powers on but will not start. If the dryer is not level, the sensing does not work properly, and your drying cycle will end early.

Next, Find The Sensor And Disconnect It From The Wiring Harness.

The sensing light is supposed to blink when the appliance is doing its work. All whirlpool duet dryers have sensor strips in the drum. That means if the sensing feature is not properly set or it is faulty, the dryer will end prematurely or not sense a dry laundry at all.

Leave a Reply

Your email address will not be published.